Hi Juliette,
You can read ascii data into Ferret and plot it without converting
to netCDF, or read into Ferret and then write the data to NetCDF
which makes it easier to use from then on. There's a chapter in the
Ferret Users Guide, "Converting to NetCDF"
http://ferret.pmel.noaa.gov/Ferret/documentation/users-guide/converting-to-netcdf
and also look up "ASCII Data" in the Users Guide index.
Ansley
On 2/1/2011 12:21 PM, Juliette Harrington wrote:
Hi
ferreters,
Does anyone know how to convert a text file into netcdf so that I
can see the data (volcanic eruptions) on ferret?
Thanks in advance,
Juliette
----- Original Message -----
From: Kankan Sarkar <kankan.math@xxxxxxxxx>
Date: Tuesday, February 1, 2011 12:08 am
Subject: Re: [ferret_users] more than 1 polar projection plot in
page
To: Ilana Wainer <wainer@xxxxxx>
Cc: ferret_users@xxxxxxxx
> Ilana,
>
> You
can give the following commands, so that you may plot four graph
in a page:
>
>
>
> yes?
set viewport ul
> yes?
(now give your command to plot & the plot will create at upper
left position)
>
> yes? set viewport ur
> yes?
(now give your command to plot & the plot will create at upper
right position)
>
> yes? set viewport ll
> yes?
(now give your command to plot & the plot will create at lower
left position)
>
>
> yes? set viewport lr
> yes?
(now give your command to plot & the plot will create at lower
right left position)
>
>
> On Fri, Jan 28, 2011 at 9:07
AM, Ilana Wainer <wainer@xxxxxx> wrote:
>
Ok - can someone help me make: set view left/right
or set view upper/lower when plotting polar projections? How
do I get more than one of these plots in a page???
> thanks
> Ilana
>
>
>
>
> --
>
Kankan Sarkar
>
Junior Research Fellow
>
School of Oceanographic Studies
>
Jadavpur Universitty
>
Kolkata, India
>
Pin No- 700 032
>
Mob.09635557334
>
>
>
|